Assembly - Greencut JET-2800SX Manuel D'utilisation

72

ASSEMBLY

Follow the following assembly instructions:
1. Insert a wheel axle (A) through each wheel (B).
2. Push each axle into the frame axle tube (C).
3. Insert a "R" clip (D) through the hole in the axle, so the axle is secured.
B
4. Insert the handle (E) into the frame tubes (F). The handle can be inserted with the hand-hold bend facing
either way. Press the spring-loaded pins (G) in so the handle tube can pass over them. When the pins "pop"
through the holes in the handle, the handle is assembled correctly.
E
F
5. Insert the ends of the hose hanger (H), from the rear of the machine and with the "hooked" section facing
up, through the holes (I) in the handle. Secure the hanger with the nuts and washers. Tighten (rotate right)
the fasteners using a suitable spanner.
PUMPS
The machine comes supplied with pump and components necessary for normal use. Some machines may include
extra or optional lance attachments, nozzles, extension hoses etc. The basic methods for connecting hoses and using
various fittings remains the same. Some information below may or may not apply explicitly to your machine.
A
H
C
G
D