Ryobi RB101 Manuel D'utilisation page 10

Once flat surfaces have been covered, polish curved surfaces
such as car doors and quarter panels. Use small circular
motions. Grip polisher with your hands at 3 and 9 o'clock
so that the cord hangs free.
After applying polish to the entire surface, turn polisher off
by pushing the ON/OFF switch with your thumb. Wait until
the pad stops rotating before lifting the polisher from the
surface. Unplug polisher.
For hard to reach areas, such as the underside of bumpers
or side mirrors, apply polish by hand.
CALIFORNIA PROPOSITION 65
wARNING:
This product and some dust created by power sanding, sawing, grinding, drilling, and other construction activities may
contain chemicals, including lead, known to the State of California to cause cancer, birth defects, or other reproductive
harm. Wash hands after handling.
Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products and,
• arsenic and chromium from chemically treated lumber.
Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your
exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially
designed to filter out microscopic particles.
OPERATION
CHANGE TO BUFFING BONNET
See Figure 6, page 13.
Remove the application bonnet by pulling the bonnet edges
over and off the pad. Replace with buffing bonnet, attaching
it the same way as the application bonnet.
Buff the surface in the same order as it was polished, starting
with large flat surfaces and ending with hard-to-reach areas.
Use the same motion as for polishing, a broad sweeping criss-
cross pattern on large flat areas and small circular motions
on all other areas. Remember to let the tool do the work.
10 — English