Tips For Troubleshooting - Abus TVAC19000A Notice D'utilisation

9. Tips for troubleshooting

No. Questions
1 The camera has not
been found.
2 Your Wi-Fi is not shown
in the selection list in the
camera app.
3 No picture is displayed.
4 Low network signal or
poor picture quality
5 What could be the
reasons why the device
does not record when
there is movement?
6 The camera picture is
obscured (white patches
on the image).
7 What could be the
reasons for an SD card
fault?
8 The display for the time
and date is not correct.
Answers
Check the following points:
1. Make sure that your network supports DHCP.
2. Are the mobile device and the camera in the same network?
Make sure that both devices are in the same network at the
initial configuration.
3. The router has no power supply.
4. The camera has no power supply.
5. Try to add the camera by entering the data manually.
If your personal Wi-Fi is not shown in the selection list, check the
following:
1. Make sure that the SSID of your router is visible.
2. Change the encryption type of your router to
WPA/WPA2/WPA2-PSK.
Check the following points:
1. Is the camera plugged in and switched on? Make sure that
the power supply unit is not defective and that the power
supply is connected.
2. Is the camera installed in the surrounding area of the the
network?
3. Make sure that the camera is correctly configured.
4. Make sure that your mobile end device is in the network or in
the 3G network.
Possible reasons are:
1. Wi-Fi network devices can impair the signal transmission.
Make sure there is enough distance between the camera and
other Wi-Fi devices.
2. Remove any dirt from the camera. This can badly affect the
picture quality.
Possible reasons are:
1. Is the SD card inserted properly?
2. Is the motion detection activated?
3. Format the SD card before using for the first time.
4. Make sure that you use a Class 10 SD card.
The camera is equipped with IR LEDs for the night mode. The IR
light is reflected on surfaces, such as glass. Do not position the
camera in front of glass surfaces and ensure that it is installed in
protected outdoor areas.
Please check the following:
1. Make sure that the SD card was inserted and formatted
correctly. Save important data before the formatting, as
afterwards it will be no longer available.
2. Make sure that you only use one Class 10 SD card.
Possible reasons are:
1. Are the date and time settings on your mobile end device
correct?
2. Is the correct time zone selected?
3. The system takes the time from the internet as soon as it is
connected. Make sure that the camera is connected to the
internet.
51
English