Stove Preparation - EQUATION CUBE Manuel D'installation, D'utilisation Et D'entretien

3.2 STOVE PREPARATION

Once determined the stove location, you can proceed to remove the packaging
The oven is packaged in a wooden box with a rigid plate.
Firstly:
Remove the wooden box
•
Unscrew the wooden plank in order to release the stove
•
• Open the door of the fireplace and take the accessories:
Power cable, rubber feet (picture A1, A2)
•
• Opening door handle
In case you need to move the stove, you should be careful not damaging vacuum engines which are placed at the button
of the stove.
Before starting the stove installation:
• Screw the rubber feet to the bottom part of the stove
• Check that the door opens and closes properly.
• Plug the power wire into the outlet located at the bottom rear of the stove (picture B)
3.. FRESH AIR INTAKE CONNECTION
In order to ensure a good performance and a good temperature distribution, the stove must be installed in a
•
place where the amount of air necessary for combustion reaches it, according to the installation standards and
rules of each country. (The possibility of air inlets or connections to external areas should be evaluated).
• The air should enter through permanent wall openings (next to the stove) towards the exterior with a section of
minimum 100 cm². Ensure that there are no objects obstructing these openings.
The air can be recovered from adjacent rooms or by free and permanent external intake.
•
• The permanent openings must meet the criteria described•
Do not use the stove in the bedroom, the bathroom or in a place where there is a risk of fire: garage, firewood
•
storage, storage of flammable material, or exercise an activity with risk of fire around this area.
• The fresh air intake for the combustion must be connected directly to the exterior side of the building, where
other heat generators are placed.
A
1
104
A
2
B