Sony CDX-GT56UI Mode D'emploi page 19

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CAUT ALM*
(Caution Alarm)
1
Activates the caution alarm: "ON,"
"OFF" (page 5).
AUX-A*
(AUX Audio)
1
Activates the AUX source display: "ON,"
"OFF" (page 20).
AUTO OFF
Shuts off automatically after a desired
time when the unit is turned off: "NO,"
"30S (Seconds)," "30M (Minutes)," "60M
(Minutes)."
REAR/SUB*
1
Switches the audio output: "SUB-OUT"
(subwoofer), "REAR-OUT" (power
amplifier).
DEMO (Demonstration)
Activates the demonstration: "ON,"
"OFF."
DIMMER
Changes the display brightness: "ON,"
"OFF."
M.DISPLAY (Motion Display)
– "SA": to show moving patterns and
spectrum analyzer.
– "OFF": to deactivate the Motion Display.
AUTO SCR (Auto Scroll)
Scrolls long items automatically: "ON,"
"OFF."
ZAP TIME (Zappin Time)
Selects the playback time for the
ZAPPIN function.
– "Z.TIME-1 (about 6 seconds),"
"Z.TIME-2 (about 15 seconds),"
"Z.TIME-3 (about 30 seconds)."
ZAP BEEP (Zappin Beep)
Has the beep sound between track
passages: "ON," "OFF."
LPF FREQ*
(Low Pass Filter Frequency)
3
Selects the subwoofer cut-off frequency:
"50Hz," "60Hz," "80Hz," "100Hz,"
"120Hz."
LPF SLOP*
(Low Pass Filter Slope)
3
Selects the LPF slope: "1," "2," "3."
SW PHASE*
(Subwoofer Phase)
4
Selects the subwoofer phase: "NORM,"
"REV."
HPF FREQ (High Pass Filter Frequency)
Selects the front/rear speaker cut-off
frequency: "OFF," "50Hz," "60Hz,"
"80Hz," "100Hz," "120Hz."
HPF SLOP (High Pass Filter Slope)
Selects the HPF slope (effective only
when HPF FREQ is set to other than
"OFF"): "1," "2," "3."
LOUDNESS (Dynamic Loudness)
Reinforces bass and treble for clear
sound at low volume levels: "ON,"
"OFF."
ALO (Automatic Level Optimizer)
Adjust the playback volume level of all
playback sources to the optimum level:
"ON," "OFF."
PARENTAL*
2
Sets the parental lock to "ON" or "OFF,"
and edits the passcode (page 20).
BTM (page 9)
*1 When the unit is turned off.
*2 When the SiriusXM tuner is connected.
*3 When the audio output is set to "SUB-OUT"
or Rear Bass Enhancer is set to other than
"OFF."
*4 When the audio output is set to "SUB-OUT."
19

Publicité

Chapitres

Table des Matières
loading

Table des Matières