Siemens slider SL45 Notice D'utilisation page 21

problem possible causes
The appliance • Water is being pumped into the
makes a pumping steam tank.
sound. • Water tank (1) is not correctly
inserted in the housing.
• The sound will not stop.
Loss of pressure • Steam release button has been
during ironing. activated for too long a period of
time, that is, it has been pressed
too frequently.
Water spots appear • May be caused by steam
on the garment condensed on the ironing board.
during ironing.
Water spots appear • Water spots are caused by steam
on the garment condensation in the hose when
during use of the cooling down after use.
"pulseSteam"
function.
The hose gets hot • This is normal. It is caused by the
during use. steam passing through the hose
during steam ironing.
Water leakage from • Filter (4) located at the side of the
the boiler. appliance is loose.
The iron does not • "pulseSteam" function has been
stop steaming after activated by double click.
placing it on the pad
(2).
If the above does not solve the problem, get in touch with an authorised technical service.
You can download this manual from the local homepages of Siemens.
Solution
• This is normal.
• Adjust the water tank to fit correctly.
• If the sound will not stop, do not use
the steam generator and contact an
authorised technical service centre.
• Use the steam release button at
intervals. This improves the ironing
result as the textiles will be steamed,
dried and ironed properly.
• Wipe the textile cover of the ironing
board, and iron any water drops to dry
them.
• Water drops stop coming out of the
soleplate after using the "pulseSteam"
function for some time.
• Place the hose on the opposite side so
that you cannot touch the hose during
ironing.
• Tighten up the filter.
• Just press the trigger once again and
the iron will stop steaming at once.
21
SIEMENS