Basic Operations - Kenwood ProTalk TK-3301 Mode D'emploi

1 Turn the Power switch/ Volume control
clockwise to switch the transceiver power
ON.
• A beep sounds if enabled by your dealer.
2 Press the key programmed with the Monitor
or Squelch Off (Side 2 key default) function
to hear background noise, then rotate the
Power switch/ Volume control to adjust the
volume.
3 Rotate the Channel selector to select your
desired channel.
• When you receive an appropriate signal, you
will hear audio from the speaker.
4 To make a call, press and hold the PTT
switch, then speak into the microphone using
your normal speaking voice.
• Hold the microphone approximately 3 to 4 cm
(1.5 inches) from your lips.
5 Release the PTT switch to receive.
Note: When the battery pack voltage becomes too low, transmission
will stop and an alert tone will sound.
8

BASIC OPERATIONS