Auxiliary Handle; Depth Stop; Extraction - Festool BHC 18 Li Guide D'utilisation

Auxiliary handle

We recommend working with an auxiliary
handle [5-1] to ensure a safe, non-tiring
working posture.
Attaching the auxiliary handle [5]

Attach the auxiliary handle [5-1] to the neck of
the gear housing.

Turn the grip anticlockwise until the auxiliary
handle [5-1] is secured in position.
5
5-1
1
2

Depth stop

 The drilling depth can be adjusted using the
depth stop [5-2].
Attaching the depth stop [5-2]

Unscrew the auxiliary handle [5-1] by turning
the grip anticlockwise.

Insert the depth stop [5-2] in the auxiliary han-
dle [5-1].

Pull out the depth stop [5-2] until the distance
between the tip of the drill and the tip of the
depth stop corresponds to the desired drilling
depth.

Tighten the grip on the auxiliary handle [5-1]
again.

Extraction

Please observe the safety regulations applicable
in your country for dust. The relevant limit values
5-2
must be observed at the workstation. A dust ex-
tractor may be required for corresponding dust ex-
posure and depending on regulations. Festool of-
fers a drilling dust nozzle in the accessories sys-
tem.
Use drill dust collection nozzle
The drill dust collection nozzle [6] has a patented
dual-chamber system for clean drilling and a se-
cure hold on floors, walls and ceilings.
 If the extractor has an automatic filter cleaning
system this must be deactivated.

Put it on the wall, floor or ceiling.

Connect the dust extractor and switch it on.
The drill dust collection nozzle clings to the sur-
face.

Place rotary hammer.
6 6
1
3
2
13