Dörr DVL-126 Notice D'utilisation page 5

Now you switch on the LED Video light using the on/off switch. The dim knob allows dimming of LED power as desired.
When you switch the light on, please note that the LEDs will take a few seconds to get to their full performance.
Notes:
• Please use always batteries of the same type, brand and capacity.
• Do not mix up batteries with rechargeable batteries.
• If you do not use the Video light for a longer while, remove the batteries.
4. Operation Time with Batteries / Battery Status Check
Using 6 fresh quality AA batteries (e.g. from Panasonic), the DVL-126 LED light will operate with full light performance for
app. 4 h, thereafter it will operate for another app. 2h at a lower power ratio. Using Li-Ion batteries the duration will vary
slightly. The battery status can be checked by pressing the test button. In case all 4 LEDs glow, the batteries are fresh
and the LED light can continue to operate with full power. As long as 1, 2 or 3 LEDs light up, the LED light can operate with
reduced power. If you require full power illumination, replace the batteries or recharge the Li-Ion battery in use.
5. Mounting the LED light on the Camera or Camcorder
Slide the foot of the LED light onto your camera's or camcorder's flash hot shoe Once it is positioned firmly, you can adjust
the tilting angle of the light by moving the hinged bracket to the desired position. Now switch your camera/camcorder on
and switch the LED light on. You can start taking pictures or filming.
6. Using the supplied Diffusers
The LED light provides a neutral daylight of app. 5.400°K color temperature. If you require a softer illumination, you can
slide the supplied white diffuser into the bracket in front of the LEDs. In case you need a more warm light, use the orange
diffuser. It provides a color temperature of app. 3.200°K. Further light effects are possible using the rose colored minus
green filters.When using the diffusers, make sure to set your camera's white balance to "manual". For details, please read
your camera's manual.
Note:
• In order to avoid blurred images, we recommend the use of a tripod.
7. Specifications:
Well suited for:
Color Temperature:
Light Intensity:
Power Source:
Adjustable Power Ratio:
Operation Time:
Battery Status Check:
Mounting on Camera:
Measurements:
Weight :
Included :
Specifications are subject to change without notice.
digital SLR cameras and camcorders
app. 5.400°K (daylight)
app. 950 Lux/1m at full power ratio (depending on power source
6x 1,5V AA battery or Li-Ion battery Panasonic SD, Sony F, FM or FH series (not included)
from 10 to 100 %
full power ratio – app. 4 h (depending on batteries in use)
reduced power ratio: app. 6h
test button and 4 LEDs
fits on the camera's flash hot shoe
141 x 48 x 150 mm
app. 240 g (w/o batteries)
LED panel, 3 diffusers, 2 battery holders
5.