Resetting The Filter Change Indicator; Cleaning Front Panel; Cleaning Particle Sensor; Maintenance Check - Nikken Air Wellness Power5 Guide De L'utilisateur

RESETTING THE FILTER CHANGE INDICATOR

To reset the Power5 change filter indicator, first make sure the unit is plugged in to an
electrical source, and the power button is in the off position. Remove the front cover of
the unit, as described in the filter replacement sequence.
On the front of the Power5 unit, facing you, the upper right area has a square-shaped
cavity. To the lower left of this is a round depression about the size of a dime (approximately
3/4 inch or 1.75 cm), with a smaller hole inside the bottom of it. This is the reset switch.
Using the tip of a pen or pencil, gently press in the center of this small hole, and hold
for ten seconds. This resets the filter indicator. Replace the Power5 front cover.

CLEANING FRONT PANEL

Clean the front panel when it becomes dusty. Sensors in the front panel must be
clean for optimum operation.
Dust the front panel or if necessary wipe with a damp cloth. Do not use solvents,
chemical cleaners or a stiff brush to clean the panel.

CLEANING PARTICLE SENSOR

The particle sensor must be clean for optimum operation. Clean the particle sensor at
least once a month by vacuuming.
MAINTENANCE CHECK\
Check the unit periodically (at least every six months) to make sure the following
conditions do not occur:
• Power cord or electric outlet is hot.
• Power cord is damaged.
If these problems are present, discontinue use of the Power5™ and consult your
service representative.

TROUBLESHOOTING

PROBLEM
• Unit will not operate.
• Unusual noise
during operation.
• Unit is operating but front
panel lights are not on.
• Unit or filters are new but
CHANGE indicator light
is on.
POSSIBLE CAUSES
• Unit may be unplugged.
• Unit may be tilted.
• Remote control battery
may need replacing.
• Air outlet may be wet.
• Panel light off function
has been selected.
• Indicator light reset
switch is out of position.
-11-
SOLUTIONS
• Check to make sure the unit is
plugged in.
• Make sure the unit is upright.
• Replace battery in remote control.
• Some sound during operation is
normal, if the room is humid. If noise
persists in a dry room, consult your
customer service representative.
• Use remote control to turn panel
lights on.
• Remove front panel as described in
the REPLACING FILTERS section.
Locate reset switch at upper right on
the front of the unit. Press the switch
and replace the front panel.