Adjusting The Particle Sensor - Nikken Air Wellness Power 5 Pro Manuel Du Propriétaire

Adjusting the particle sensor

The particle sensor is set at a moderate level of sensitivity. The degree of sensitivity
controls the point at which the Power5 Pro (in auto mode) increases or decreases its
fan speed in response to room conditions.
The particle sensor should be readjusted after the Power5 Pro:
• Has been operated continuously for more than two hours in a room with a high
level of dust or contamination, or
• Has been operated at its lowest setting for more than one hour, in these conditions.
Adjust the particle sensor as follows:
1. Press the POWER button to activate the Power5 Pro.
2. Press both the MODE and SPEED buttons and hold,
until the air-quality display begins to flash.
3. Use the SPEED button to reset the sensor to the
desired level. This is indicated by the numbers in
the speed display. The number 1 calibrates the
sensor to make it highly sensitive to airborne
contaminants. Number 2 is a medium setting, and
number 3 is less sensitive.
4. When you have selected the desired number, press
both the MODE and SPEED buttons again and hold for
three seconds. The sensor is now reset.
All manuals and user guides at all-guides.com
-11-