Replacing Filters - Nikken Air Wellness Power 5 Pro Manuel Du Propriétaire

2. Clean the filter by gently vacuuming or by immersion in warm water.
3. If washed, allow the filter to air dry completely before replacing it in the unit.

Replacing filters

Reinsert the filter and reattach the front panel.
All the filters should be replaced at the same time. Inspect at least once every 6 months,
or more often if used in an area with higher than average levels of air pollution.
Do not operate the unit without filters in place.
1. Remove the front panel of the unit by placing fingers inside the side air inlets
and pulling the panel slightly outward at the
bottom. Then lift the panel upward to remove
and set aside.
2. The prefilter/mesh filter includes two projecting
tabs in the center of the frame. Gently pull
these tabs to remove filter. Set the filter aside
and retain it for further use.
3. The front of the neutralizing filter includes a
small pull tab at top or bottom edge. Gently pull
this tab to remove the filter.
4. Follow this same procedure to remove the
activated carbon and HEPA filter elements. Discard the used neutralizing,
activated carbon and HEPA filters.
5. Remove the new filter elements from packaging. CAUTION: When inserting the
replacement elements, make sure to install in the proper order. If filters are not
placed in the correct sequence, operation may cause damage to the unit. First
insert the HEPA filter into the back of the filter space. Push the filter all the way
into the space, at all corners. Make sure that the front of the HEPA filter (labeled
FRONT) is facing toward the front of the unit, and the pull tab is exposed.
6. Follow this same procedure in inserting the activated carbon filter. Next insert
the neutralizing filter. Make sure that both are placed with the labeled front
surface of the filter toward the front, and the pull tab is exposed.
All manuals and user guides at all-guides.com
-14-