Fhiaba Brilliance Série Notice D'installation page 19

6
7
8
9
Ensure the top adjustment L-brackets are aligned and inserted
into the cavities at the top of the door
Make sure all the hanger brackets begin above the hanger bolts
and then lower the panel down checking that each hanger brack-
et has engaged its corresponding hanger bolt.
At this point, alignment between the panel and adjacent cabi-
nets can be adjusted using the alignment brackets and small brack-
ets and .
7 8
Vertical alignment: tighten or loosen the screw in the brackets to
raise or lower the panel
9
Depth alignment: working from the inside of the door, after lift-
ing up the magnetic seal, adjust the panel position so it is closer to
or further away from the door using the holes
panel in position using the holes
10
11
Installation Guide
Series: Brilliance Integrated (BI)
.
6
.
and then fix the
10
.
11
Once the front panel has been ad-
justed, check that the gasket has
been repositioned correctly to as-
sure the door/drawer are closing
correctly and avoid operational er-
rors of the unit.
www.fhiaba.com · www.thevettagroup.com 17