Fein BOP6 Mode D'emploi page 12

OBJ_BUCH-0000000002-001.book Page 12 Tuesday, July 21, 2009 1:32 PM
en
12
en Original Instructions for Drill.
Symbols, abbreviations and terms used.
Symbol, character Explanation
Do not touch the rotating parts of the power tool.
Make sure to read the enclosed documents such as the Instruction Manual and the General
Safety Instructions.
Before commencing this working step, pull the mains plug out of the socket. Otherwise there
will be danger of injury if the power tool should start unintentionally.
Use eye-protection during operation.
Use ear protection during operation.
Additional information.
Confirms the conformity of the power tool with the directives of the European Community.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
WARNING
Worn out power tools and other electrotechnical and electrical products should be sorted
separately for environment-friendly recycling.
Product with double or reinforced insulation
Ø Diameter of a round part
1st gear/2nd gear
Drilling diameter, steel
Fe
Drilling diameter, aluminium
Al
Drilling diameter, wood
Tap
d1 = Clamping range of drill chuck
d2 = Shank size of drilling shaft
d3 = Collar diameter
Weight according to EPTA-Procedure 01/2003
Low speed
High speed