Publicité
Les langues disponibles
Les langues disponibles
Connect the plug into the power point. The heater is a Class II appliance and it does not
require an earth connection.
Select the required power using the power selector and move the thermostat control to
maximum position.
Power selector (Fig.1C).
O
Stop
Fan (cold air)
I
Hot air heater (800W)
II
Very hot air heater (1800W)
Thermostat (Fig.1B)
Min.
Once the room has reached the desired temperature, slowly move the control until
there is a soft "click" and the device is disconnected. From this time the heater
turns on and off automatically, keeping the pre-selected comfort temperature.
Note : The LED is illuminated whenever the heater is operating.
Anti frost device
This device is especially useful in places where low temperatures are reached and
there is a risk of water freezing in internal water pipes. The heater will
automatically maintain the temperature of the room at about +5ºC when left on this
setting.
4.
Maintenance
Before carrying out any maintenance work, make sure that the device has been
disconnected from the mains and let the heater cool down for a few minutes.
Periodically, to prevent an accumulation of dust, clean the inlet and outlet air (Fig 1F-A)
with a damp cloth or a vacuum cleaner. Never use petrol or aggressive and/or abrasive
dissolvents to clean the device.
Do not immerse the device or spray with water.
If the appliance is not to be used for any length of time, we recommend returning it to its
original package and storing it in a dry, dust-free place.
Max.
11
Publicité
