Installation Notes; Installation; Conversion From Pre Fader Mode To Post Fader Mode - Electro-Voice IRIS Net RCM-26 Mode D'emploi

1.3 Installation Notes

Installation

1. Switch the power amp's power off and pull the mains plug
2. Remove the cover panel from the rear panel (4 screws)
3. Insert the RCM-26 module in the slot and lock it in place on the rear panel
using the 4 screws (see illustration 1.1)
4. Set the module's CAN-address using the ADDRESS selector switches
5. Connect the needed interfaces (CAN, Audio, Control Port, RS-232)
6. Reconnect the mains cord and switch on the power amplifier
7. The power amp automatically recognizes the installed RCM-26 module

Conversion from Pre Fader Mode to Post Fader Mode

The RCM-26 is shipped from the factory in the recommended "Pre Fader"
mode, so the input level controllers on the front of the amplifier are taken out of
operation by installation of the RCM-26. If the input level controller are to be
usable with a RCM-26 installed, the RCM-26 must be converted to "Post Fader"
mode.
RCM-26 Remote Control Module
8
Owner's Manual
Illustration 1.1: Installation of a RCM-26