Electro-Voice IRIS Net RCM-26 Mode D'emploi page 69

Frequency Response
Signal to Noise Ratio
(A-weighted)
THD+N
Signal Delay
Crosstalk
SIGNAL PROCESSING
Sample Rate
Data Format
Signal Processing
Master EQ (Input)
Master Delay (Input)
Channel EQ (Output)
X-Over
FIR Filters
Dynamics
Other Functions
Protection
INTERFACES
RS-232
CAN
20 Hz...40 kHz (-1.0 dB)
ADC: 120 dB typical
DAC: 118 dB typical
AES3: 128 dB typical
Analog In to Analog Out: 116 dB typical
< 0.005 %
1.031 ms @ 96 kHz
< -110 dB @ 1 kHz
96 kHz (48 kHz optional)
24 Bit linear A/D and D/A conversion, 48 Bit
processing
2 DSPs (150 MHz, 300 MIPS)
6 filters per channel, selectable as PEQ, Lo-
Shelf, Hi-Shelf, Hi-Pass and Lo-Pass
2...2000 ms per channel (units: µs, ms, m,
inches, feet, samples)
6 filters per channel, selectable as PEQ, Lo-
Shelf, Hi-Shelf, Hi-Pass, Lo-Pass and All-
Pass
Hi-Pass and Lo-Pass per channel, 6/12/18/
24 dB Bessel/Butterworth, 12/24 dB Link-
witz-Riley
Zero-Latency Processing, Linear Phase X-
Over
Compressor and Limiter per channel
Input Routing, Level, Mute, Polarity, Sine
and Noise Generator, Pilot Generator, Level
Meters
Digital Speaker Protection
9pin DSUB female (Multi-Media Control)
10...500 kbaud, 2 x RJ-45 (IRIS-Net™ Con-
trol)
RCM-26 Remote Control Module
69