FALMEC QUASAR Mode D'emploi page 20

2. CHARCOAL FILTERS
Remove the perimeter suction panel and the metal filters according to the indications in
section H1. Then remove the insidel panel (C) acting on the screws V1 (see fig. H1).
At this point, the two filters hooked on the right and left side of the conveyor can be ac-
cessed easily. See the figure for assembly/replacement.
To order new charcoal filters, contact your distributor/dealer.
ONLY FOR ITALY: Download the specific filter order form from the website:
www.falmec.com (access the drop-down assistance menu).
I
LIGHTING
SPOTLIGHT
How to replace a square halogen light:
a) Check that the equipment is disconnected from the power supply.
b) Open the panel completely till 90° (see figure) pressing the PUSH button
c) Replace the lamp with a similar one (halogen, max 20 W, 12 Volt, G4 connection).
d) Close the panel. If the panel does not close correctly repeat the operation at point b.
L
MAINTENANCE AND CLEANING
Constant maintenance ensures the correct operation and efficiency of the appliance over
time. Special attention should be paid to the metal grease-trapping filters and the charcoal
filters. Frequent cleaning of the filters and their supports will ensure that fats and grease do
not accumulate on the range hood, with the consequent risk of fire.
1. METAL GREASE-TRAPPING FILTERS
These trap the fat and grease particles suspended in the air, and therefore should be
washed every month in hot water and detergent, without bending them. Wait until they
are completely dry before repositioning them. To remove and replace these filters, see
the instructions in point H1. This operation should be performed at regular intervals.
2. CHARCOAL FILTERS
These trap the odours present in the stream of air that passes through them. The air is puri-
18
ASSEMBLY AND REPLACEMENT