INFOSEC UPS SYSTEM E3 Performance 800 RT Notice D'utilisation page 34

Step 6 - External battery connection

Connect the external battery to the UPS thanks to an optional battery connector (in case of
extended backup time).
NOTE: Maximum connected external battery boxes up to 4 units.
Step 7 - Turn on the UPS

Press the ON/Mute button on the front panel for two seconds to power on the UPS.
Note: The battery charges fully during the first five hours of normal operation. Do not expect
full battery run capability during this initial charge period.
Step 8 - Install software

For optimal computer system protection, refer to the InfoPower software CD to fully
configure UPS shutdown.
2.5 Battery replacement
NOTICE: This UPS is equipped with internal batteries and user can replace the batteries
without shutting down the UPS or connected loads (hot-swappable battery design).
Replacement is a safe procedure, isolated from electrical hazards.
CAUTION! Consider all warnings, cautions, and notes before replacing batteries.
Note: Upon battery disconnection, equipment is not protected from power outages.
Step 1

Remove front panel.
INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
34
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)240 94 29 51 - hotline@infosec.fr – 02 17 AA 59 204 40
UPS
Disconnect battery wires.
Step 2

Battery Box
Battery Box
Step 3

Pull out the battery box by
removing two screws on the
front panel.