Kuppersbusch ITE137-0 Mode D'emploi page 21

Problem
The appliance does not
operate. The Pilot light
does not flash.
The Pilot light flashes.
The Alarm light flashes.
The compressor operates
continually.
The temperature in the
freezer is too low.
The temperature in the
freezer is too high.
There is too much frost.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The appliance is not working
properly.
The temperature in the freezer is
too high.
The temperature is not set cor-
rectly.
The door is not closed correctly.
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
The Fast freezing function is
switched on.
The temperature regulator is not
set correctly.
The Fast freezing function is
switched on.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
Products are too near to each
other.
Food is not wrapped correctly.
The door is not closed correctly.
The temperature regulator is not
set correctly.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
Contact a qualified electrician.
Refer to "Excessive Temperature
Alarm"
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature before
storage.
Decrease the room temperature.
Refer to "Fast freezing function".
Set a higher temperature.
Refer to "Fast freezing function".
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature before
storage.
Store less products at the same
time.
Store products so that there is cold
air circulation.
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.
3. If necessary, replace the defective door
gaskets. Contact the Service Force Cen-
ter.
21
Solution