Worx WX641 Mode D'emploi page 9

SYMBOLS
To reduce the risk of injury, user
must read instruction manual
Double insulation
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Waste electrical products must not
be disposed of with household
waste. Please recycle where
facilities exist. Check with your local
authorities or retailer for recycling
advice.
Finishing Sander
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for dry sanding of
wood, plastic, filler and coated surfaces.
ASSEMBLY AND OPERATION
Action
ASSEMBLY
Fitting &Removing the
Sanding Paper
Paper Punch (Optional)
Attaching the Dust Box
Caution: To prevent
the possibility of
sanding dust or foreign
body being thrown into
your face or eyes, never
attempt to use your
sander without the dust
box properly installed.
Emptying the Dust Box
-For more efficient
operation, empty dusts
box every 5-10mins.
Using the Dust Extraction
Adapter
OPERATION
Plugging in the power
Switching On/Off
Variable speed control
(only for WX642 WX642.1)
WORKING HINTS FOR YOUR
FINISHING SANDER
If your power tool becomes too hot, especially
when used at low speed, set the speed to
maximum and run it with no load for 2-3 minutes
to cool the motor. Avoid prolonged usage at
very low speeds. Always use sand paper that is
suitable for the material you want to sand.
Always ensure the work-piece is firmly held or
Figure
See Fig. A1, A2
See Fig. B
See Fig. C
See Fig. D1, D2
See Fig. E, F
See Fig. G
See Fig. H
See Fig. I
EN
9