Makita 3901 Manuel D'instruction page 8

10. For Corner Joint only
Place the tool on the workpiece so that the blade is fac-
ing down.
For T-Butt Joint only
Remove the angle guide from the tool. Place the tool on
the workpiece so that the blade is facing down.
11. Repeat the steps 6 - 8 to cut the slots in the hori-
zontal or the other workpiece.
If you do not need to center the blade in the board thick-
ness, proceed as follows:
For Corner Joint, Miter Joint, Frame Joint and Edge-
To-Edge Joint only
• Remove the angle guide from the tool. Set the
fence at 90° for Corner Joint, Frame Joint and
Edge-To-Edge Joint or at 45° for Miter Joint.
• Follow steps 1 - 11 excluding steps 5 and 10
described above.
004599
004600
004601
For T-Butt Joint only
• Fit the two workpieces together as they will appear
in the finished joint position.
• Lay the vertical workpiece on the horizontal one.
Clamp both workpieces to the workbench.
• Remove the angle guide from the tool.
• Follow the steps 2, 4, 6, 7, 8 and 11 described
above.
How to trim wall or ceiling panels
First unplug the tool. Open the blade cover and replace
the existing cutter blade with an optional circular saw
blade 110 mm (4-3/8") in diameter.
1
2
3
Refer to the "Removing or installing the blade" section
which was described previously. Remove the rubber fac-
ing from the base. Then close and secure the blade
cover. Now the max. depth of cut is 25 mm (1").
8
004602
004603
004604
1. Lock nut
4
2. Circular saw
blade
3. Inner flange
4. Blade cover