Makita 3901 Manuel D'instruction page 7

For Frame Joint and Edge-To-Edge Joint only
Clamp one workpiece to the workbench.
1
1
4. Set the depth of cut according to the size of biscuit
to be used. Refer to the table in the "Adjusting the
depth of cut" section.
5. Adjust the angle guide height so that the blade is
centered in the board thickness.
6. Align the center mark on the base with the pencil
line on the workpiece.
7. Switch on the tool and gently push it forward to
extend the blade into the workpiece.
8. Gently return the tool to the original position after
the adjusting screw reaches the stopper.
9. For Corner Joint and T-Butt Joint only
Clamp the horizontal workpiece to the workbench.
1
004591
1. For Frame Joint
004592
1. For Edge-To-
Edge Joint
004593
004594
1. For Corner Joint
1
For Miter Joint only
Clamp the other workpiece to the workbench with the
mitered edge facing up.
For Frame Joint and Edge-To-Edge Joint only
Clamp the other workpiece to the workbench.
1
1
7
004595
1. For T-Butt Joint
004596
004597
1. For Frame Joint
004598
1. For Edge-To-
Edge Joint