Publicité
Les langues disponibles
Les langues disponibles
Operating instructions SATAjet 1000 KK
4.3 Correct adjustment of the dynamic inlet pressure
a) Spray gun with micrometer / gauge
Ensure sufficient pressure by means of the pressure regulator. Adjust the
recommended inlet pressure of 1,5 - 2,0 bar/22 - 29 psi at the micrometer.
Art. No. 27771
b) Spray gun equipped with compressed air control gauge
Adjust the pressure at the pressure regulator in a way that the spray gun
inlet pressure required for the respective gun model is obtained.
Art. No. 4002
c) Spray gun without gauge
In order to make a correct adjustment of the spray gun inlet pressure, as
otherwise measureable in a) to b), without a gauge, adjust a pressure of
about 9 psi higher per 10 m to inlet pressure to compensate the pressure
drop in the hose.
4.4 Material flow control
Adjust material flow control
in accordance with spray viscosity and required flow rate (arrow 1 ) and fix
by means of the counter nut (arrow 2 ). Under normal circumstances, the
material flow control is fully open.
4.5 Nozzle set
Complete, hand-checked nozzle-set, consisting of paint needle (V4A) and
paint nozzle (V4A). Mount the nozzle set tightly (use universal wrench for
the paint nozzle). Insert paint nozzle before putting in paint needle. Use pun-
ched hexagon socket (wrench size 12) of universal wrench for paint nozzle.
Only original SATA parts guarantee highest quality and lifetime.
4.6 Spray distance
To avoid overspray and surface problems, make sure to paint with the correct
spraying distance between gun nozzle and the object to be painted and to
adjust the spray gun inlet pressure accordingly.
Version
jet 1000 KK
II.3
Spray distance
18 - 23 cm/7 - 9 inches
Gun inlet pressure
2,0 - 2,5 bar/29 - 36 psi
2
1
Publicité
