Bosch HBL6EI23 Notice De Montage Et D'installation page 13

Connecting to natural gas
A
B
Connecting to liquefied gas
A
B
Proceed as follows:
• Screw the connecting piece (C) and the seal (B)
to the gas connection (A).
• Hold the ISO 228-1/ISO 7-1 connection angle (C)
C
in place with a spanner and screw the connecting
piece to a fixed supply pipe or a flexible gas
connecting hose (D).
Only use supply pipes or flexible hoses which
D
comply with the applicable regulations and which
are approved for this purpose.
Only use approved sealing compound to seal the
thread.
Proceed as follows:
• Screw the ISO 228-1/ISO 228-1 connection angle
(C) and the seal (B) to the gas connection (A).
• Screw the corrugated tube nipple (E) and the seal
C
(D) to the connection angle (C+A).
• Hold the corrugated tube nipple (E) in place with
a spanner and screw the connecting piece to a
D
flexible gas connecting hose (G).
• Tighten the clamp (F).
E
Only use supply pipes or flexible hoses which
F
comply with the applicable regulations and which
are approved for this purpose.
G
Only use approved sealing compound to seal the
thread.
11