Omron M1 Plus Mode D'emploi page 24

HEM-4011C.book Page 24 Tuesday, August 9, 2005 10:35 AM
3.Using the Unit
Note: If there are no measurements results stored in
memory, the screen to the right is displayed.
3.
Press the MEMORY button again,
while the average values screen is
displayed.
The result from the most recent
measurement is displayed.
The date and time of each
measurement is displayed alternately
with the measurement values.
Important: If your systolic or diastolic pressure
is outside the standard range, the
heartbeat symbol will blink when
the measurement result is
displayed. Refer to 3.3, number 7.
4.
Press the MEMORY button
repeatedly to cycle through the
previous measurement results.
Keep the button pressed down to
cycle rapidly through the previous
results.
If the irregular heartbeat symbol was displayed at the time of a
measurement, this is displayed when that result is displayed.
5.
Press the I/O button to turn the unit off.
If you forget to turn the unit off, it will automatically shut itself off
after five minutes.
24