Basic Settings On The Transmitter; Synchronising The Controller With The Remote Transmitter - Carson DRAGSTER XL BRUSHLESS-Regler Mode D'emploi

1. Basic settings on the transmitter

To ensure that best operation of the electronic speed controller is not
compromised by default settings on the transmitter, certain settings on
the remote transmitter should be reset before programming the speed
controller.
• Set the upper end stop for the throttle/brake servo to maximum by
selecting the highest level for the upper EPA/ATV setting.
• Set the lower end stop for the throttle/brake servo to maximum as
well by selecting the highest level for the lower EPA/ATV setting.
• Set the trim of the throttle/brake lever to the middle position.
2. Synchronising the controller with the remote
transmitter
• Switch on the transmitter.
• Connect the controller to the power supply.
• Hold down the SET button and switch the controller on at the
on/off switch.
The green LED lights up.
• Set the throttle/brake lever to the full acceleration position.
The green LED lamp flashes.
The full throttle setting is stored.
• Return the throttle/brake lever fully.
The red LED lamp flashes.
The brake setting is stored.
• Put the throttle/brake lever to neutral.
The red and green LED lamps flash briefly.
• Switch the controller off.
When you switch the controller on again, the speed controller is
synchronized to the transmitter and is fundamentally ready for use.
DRAGSTER XL Brushless-Regler
GB
13