English - Philips GC9600 Mode D'emploi

ENGLISH

8
During ironing, you can place the iron either on the iron
platform or horizontally on the ironing board. Thanks to the
OptimalTEMP technology, the soleplate will not damage the
ironing board cover.
Ironing
1 Place the steam generator on a stable and even surface.
2 Make sure that there is enough water in the water tank
(see section 'Filling the water tank').
3 Put the mains plug in an earthed wall socket and press the
on/off button to switch on the steam generator. The blue
power-on light on the appliance and the 'iron ready' light
start to flash to indicate that the appliance is heating up
(this takes approx. 2 minutes).
When the appliance is ready for use, the 'iron ready
,
light' and the power-on light stop flashing and light up
continuously. Additionally you hear a short beep.
4 Press the carry lock release button to unlock the iron from
the iron platform.
5 Press and hold the steam trigger to start ironing.
Never direct steam at people.
Note: For best result on tough fabrics such as cotton, linen
and jeans, keep the steam trigger pressed continuously when
you move the iron over the fabric. Then move the iron over
the same area a few more times without steam to dry the
fabric.
Note: For the best results on silk and shiny synthetic fabrics,
it is recommended to keep the steam trigger pressed
continuously while ironing.