Casselin CLVACPV Mode D'emploi page 23

During washing, the screen alternately shows the display of the measured water temperatures and the
selected washing cycle, alternated with the display of the washing phase in progress, the estimated
residual time until the end of the cycle , and a diagram indicating the evolution of the washing phase (inner
circle) and rinsing (outer circle).
At the end of the wash the appliance emits an acoustic signal.
You can then open the hood, remove the basket with the clean dishes, load the dishwasher with a basket
of dirty dishes and carry out a new wash cycle.
If the water heater standby device has been activated, at the end of the washing phase, the appliance will
not cycle if the water heater temperature does not correspond to that selected. The cycle restarts with the
rinsing as soon as the temperature is reached.
After washing
1- Empty the tank by removing the plug located in the tank itself. If the dishwasher is equipped with an
automatic drain pump, press the button.
2- Switch off the appliance by pressing the on button
3- Close the main electrical wall switch
4- Close the water supply tap
5- Check and clean the washing filters properly.
NOTE
The device is fitted with a safety system in the event of overheating. If tripped, unplug the device and allow it
to cool. If this protection system operates regularly, it is imperative to contact your dealer.
After automatic shutdown, the device can only be put into service by pressing the Reset button on the back
of the device, wait for the temperature to drop, press the Reset button.
.
for 3 seconds
EN