Casselin CLVACPV Mode D'emploi page 20

Filling of detergent and rinsing liquid dosing circuits.
For the operation of the metering units, see the "metering units" paragraphs.
For their correct functioning, the liquid suction pipes (exiting at the rear of the appliance) must be filled. The
continuous actuation of the dosers necessary for this filling operation is obtained by placing the device in
the situation in which parameters 08 and 09 must be modified respectively (see paragraph 5.2) and by
pressing the key. .
The metering unit remains active as long as the button is pressed.
NOISE
The sound level of the side and front walls is less than 70 dB (A).
DESCRIPTION OF THE APPLIANCE
1) Control panel
2) Plate basket
3) Spray arm
4) Rinsing arm
5) Hood opening / closing handle
Security devices

HOOD MICRO-SWITCH: it interrupts all the functions of the appliance when the door is opened and
does not allow starting when the door is

THERMAL PROTECTIONS FOR ELECTRIC PUMPS: these devices guarantee protection in the
event of short-circuits and overloads.

PROTECTION ON THE WATER HEATER RESISTANCE: a failure of the water heater temperature
control causes, for heaters with a minimum power of 8 kW, the intervention of a safety thermostat
which can be reset when its temperature decreases . For resistors with a lower power, the safety
function is guaranteed by a thermal fuse integrated in the resistance.

DIGITAL TANK PRESSURE SWITCH: it protects the resistance of the tank and the washing pump
against dry running. If the water level is too low, the wash pump is not activated. If the level drops
during the operating time, the tank filling solenoid valve is activated by stopping the pump and the
washing cycle.
 ANALOGUE TANK PRESSURE SWITCH: it protects the tank resistance against dry
running. If the water level is too low, the resistance of the tank is not activated.
 WATER HEATER LEVEL SENSOR (only for BA version): it protects the water heater
resistances and the rinsing pump against dry running. If the water level is too low, the
flushing pump is not activated. If the level decreases during the operating time, the tank
filling solenoid valve is activated by the tank (break tank).
DESCRIPTION OF CONTROLS
Key for activating special functions for
predisposed device
Access key to device
parameters
Parameter selection or variation
keys
Access key to device usage
information
open.
ON / OFF button
Cycle start button
Parameter selection or variation
Tank emptying button (for models
fitted with a drain pump)
keys
EN