DeWalt DC9319 Mode D'emploi page 2

4. Once the Automatic Tune Up mode is complete, the charger will begin a maintenance charge;
the red indicator will remain lit.
Troubleshooting
If the indicator light does not come on when the battery pack is inserted into the charger:
• Be sure the battery pack is inserted in the proper direction;
• Try a second pack if one is available;
• Be sure the charger plug is fully inserted into the cigarette lighter socket;
• Be sure the cigarette lighter socket is not connected to the ignition switch, so that power is
disconnected in the "OFF" position; ensure the ignition switch is in the accessories position and
the cigarette lighter operates.
• Be sure the cigarette lighter socket is clean;
• Be sure the cigarette lighter operates in the socket.
Special Installations for Vehicles without
Cigarette Lighters
The charger has an integral overload protector (fuse). DO NOT REMOVE THIS PLUG.
Purchase a female cigarette lighter receptacle from your local automotive parts store. Wire this
receptacle in accordance with the instructions provided with the cigarette lighter receptacle.
Plug your charger into this receptacle.
Modifi cation for Positive Ground Operation of Charger
For use with a vehicle with a positive ground battery, the connection to the charger plug must be
reversed.
The vehicle charger is not user serviceable. Have this modification made at your nearest qualified
D WALT certified service center.
E
OPERATION
Chargers
Be sure to read all safety instructions before using your charger. Consult the chart at the end of this
manual for compatibility of chargers and battery packs.
Charging Procedure
WARNING: Do not charge batteries in explosive atmospheres. Ignition may occur.
1. Unwrap cord and plug in the charger.
2. Place the battery pack in the charger as shown in Figure 2.
3. The indicator light will start to blink. Refer to INDICATOR LIGHT OPERATION below.
4. In about 45 minutes, for a standard battery, the indicator light will stop blinking and remain
continuously on. Fast charging is complete and your battery pack is ready for use.
5. The indicator light will remain on for an additional 16 hours while the charger maintains your
battery pack in a fully charged condition.
6. After 16 hours, the charger will shut off automatically to reduce the amount of energy drained
from the vehicle's battery.
7. The indicator light may stay on momentarily after the battery pack is removed from the charger.
ALWAYS wait for the indicator light to go out before inserting another pack.
NOTICE: To prevent excessive discharge of the vehicle battery, Do not charge more than two
battery packs without operating the vehicle.
Indicator Light Operation
Charge Indicators
Some chargers are designed to detect certain problems that can arise with battery packs. Problems
are indicated by the red light flashing at a fast rate. If this occurs, re-insert battery pack into the
charger. If the problem persists, try a different battery pack to determine if the charger is OK. If the
new pack charges correctly, then the original pack is defective and should be returned to a service
center or other collection site for recycling. If the new battery pack elicits the same trouble indication
as the original, have the charger tested at an authorized service center.
HOT/COLD PACK DELAY
Some chargers have a Hot/Cold Pack Delay feature: when the charger detects a battery that is
hot, it automatically starts a Hot Pack Delay, suspending charging until the battery has cooled.
After the battery has cooled, the charger automatically switches to the Pack Charging mode. This
feature ensures maximum battery life. The red light flashes long, then short while in the Hot Pack
Delay mode.
PROBLEM POWER LINE
Some chargers have a Problem Power Line indicator. When the charger is used with some portable
power sources such as generators or sources that convert DC to AC, the charger may temporarily
suspend operation, flashing the red light with two fast blinks followed by a pause. This
indicates the power source is out of limits.
LEAVING THE BATTERY PACK IN THE CHARGER
The charger and battery pack can be left connected with the red light glowing for 16 hours, then
turn itself off. The charger will keep the battery pack fresh and fully charged.
NOTE: A battery pack will slowly lose its charge when kept out of the charger. If the battery pack
has not been kept on maintenance charge, it may need to be recharged before use. A battery pack
may also slowly lose its charge if left in a charger that is not plugged into an appropriate power
source.
WEAK BATTERY PACKS: Chargers can also detect a weak battery pack. Such batteries are still
usable but should not be expected to perform as much work. The charger will indicate to replace
battery pack.
Important Charging Notes
1. To prevent excessive discharge of the vehicle battery, Do not charge more than two
battery packs without operating the vehicle.
2. Disconnect charger from cigarette lighter socket when not in use to prevent vehicle
battery from discharging.
3. If the battery pack does not charge properly:
a. Ensure the cigarette lighter operates when pushed in the socket.
b. Ensure the cigarette lighter operates when the vehicle's ignition switch is in the "Accessory"
position.
4. Longest life and best performance can be obtained if the battery pack is charged when the
air temperature is between 65 ˚F and 75 ˚F (18–24 ˚C). DO NOT charge the battery pack in an
air temperature below +40 °F (+4.5 ˚C), or above +105 ˚F (+40.5 ˚C). This is important and will
prevent serious damage to the battery pack.
5. The charger and battery pack may become warm to touch while charging. This is a normal
condition, and does not indicate a problem. To facilitate the cooling of the battery pack after
use, avoid placing the charger or battery pack in a warm environment such as in a metal shed,
or an uninsulated trailer.
6. The battery pack should be recharged when it fails to produce sufficient power on jobs which
were easily done previously. DO NOT CONTINUE to use under these conditions. Follow the
charging procedure. You may also charge a partially used pack whenever you desire with no
adverse affect on the battery pack.
7. Under certain conditions, with the charger plugged into the power supply, the exposed
charging contacts inside the charger can be shorted by foreign material. Foreign materials of
a conductive nature such as, but not limited to, steel wool, aluminum foil, or any buildup of
metallic particles should be kept away from charger cavities. Always unplug the charger from
the power supply when there is no battery pack in the cavity. Unplug charger before attempting
to clean.
8. Do not freeze or immerse charger in water or any other liquid.
WARNING: Shock hazard. Don't allow any liquid to get inside charger. Electric shock may result.
WARNING: Burn hazard. Never attempt to open the battery pack for any reason. If the plastic
housing of the battery pack breaks or cracks, return to a service center for recycling.
Storage Recommendations
1. The best storage place is one that is cool and dry away from direct sunlight and excess heat
or cold.
FIG. 1
2. For long storage, it is recommended to store a fully charged battery pack in a cool dry place
out of the charger for optimal results.
NOTE: Battery packs should not be stored completely depleted of charge. The battery pack will
need to be recharged before use.
MAINTENANCE
Cleaning
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC outlet before cleaning. Dirt and
grease may be removed from the exterior of the charger using a cloth or soft non-metallic brush.
Do not use water or any cleaning solutions.
Repairs
The charger and battery pack are not serviceable. There are no serviceable parts inside the charger
or battery pack.
READ ALL OF THE INSTRUCTIONS IN THE BATTERY CHARGER SECTION OF THIS
MANUAL BEFORE ATTEMPTING TO CHARGE THE BATTERY PACK FOR YOUR TOOL.
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be
performed by certified service centers or other qualified service organizations, always using identical
replacement parts.
Three Year Limited Warranty
D WALT will repair, without charge, any defects due to faulty materials or workmanship for three
E
years from the date of purchase. This warranty does not cover part failure due to normal wear or tool
abuse. For further detail of warranty coverage and warranty repair information, visit www.D
com or call 1-800-4-D WALT (1-800-433-9258). This warranty does not apply to accessories or
E
damage caused where repairs have been made or attempted by others. This warranty gives you
specific legal rights and you may have other rights which vary in certain states or provinces.
In addition to the warranty, D WALT tools are covered by our:
E
1 YEAR FREE SERVICE
D WALT will maintain the tool and replace worn parts caused by normal use, for free, any time
E
during the first year after purchase.
2 YEARS FREE SERVICE ON D
DC9071, DC9091, DC9096, DC9280, DC9360, DC9180, DCB120 and DCB201
3 YEARS FREE SERVICE ON D
D WALT BATTERY PACKS
E
Product warranty voided if the battery pack is tampered with in any way. D
for any injury caused by tampering and may prosecute warranty fraud to the fullest extent permitted
by law.
90 DAY MONEY BACK GUARANTEE
If you are not completely satisfied with the performance of your D
for any reason, you can return it within 90 days from the date of purchase with a receipt for a full
refund – no questions asked.
LATIN AMERICA: This warranty does not apply to products sold in Latin America. For products
sold in Latin America, see country specific warranty information contained in the packaging, call the
local company or see website for warranty information.
FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing,
call 1-800-4-D WALT (1-800-433-9258) for a free replacement.
E
Défi nitions : lignes directrices en
matière de sécurité
Les définitions ci-dessous décrivent le niveau de danger pour chaque mot-
indicateur employé. Lire le mode d'emploi et porter une attention particulière à ces
symboles.
DANGER : indique une situation dangereuse imminente qui, si elle n'est pas
évitée, entraînera la mort ou des blessures graves.
AVERTISSEMENT : indique une situation potentiellement dangereuse qui, si elle
n'est pas évitée, pourrait entraîner la mort ou des blessures graves.
ATTENTION : indique une situation potentiellement dangereuse qui, si elle n'est
pas évitée, pourrait entraîner des blessures légères ou modérées.
AVIS : indique une pratique ne posant aucun risque de dommages corporels
mais qui par contre, si rien n'est fait pour l'éviter, pourrait poser des risques de
dommages matériels.
POUR TOUT COMMENTAIRE OU QUESTION RELATIF À CET OUTIL OU TOUT AUTRE OUTIL
D WALT, COMPOSEZ GRATUITEMENT LE : 1-800-4-D
E
AVERTISSEMENT ! Lire et comprendre toutes les directives. Le
non-respect des directives suivantes comporte des risques de choc
électrique, d'incendie et/ou de blessure grave.
CONSERVER CES DIRECTIVES
FIG. 2
WALT BATTERY PACKS
E
WALT BATTERY PACKS
E
DCB200
WALT is not responsible
E
WALT Power Tool, Laser, or Nailer
E
WALT (1-800-433-9258).
E
WALT.
E