Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
(Blinking in red)
Output will be halted to prevent damage in the event of overloaded operations
caused by the blades in cordless power tools, etc., continuing. Resolve the reason
for the overload, and then press the power switch to resume operations.
(Swift blinking in red)
There is a possibility that damage has occurred. Cease operations immediately and
request inspections or repairs.
USED AS A USB POWER SUPPLY (DC 5V)
WARNING:
● Read the instruction manual for the USB device to be connected beforehand.
● Check to confi rm that the USB cable to be connected is not damaged before using
it.
Failure to observe this may result in the outbreak or smoke or fi re.
● Seal the USB terminal with a rubber cover when not in use.
If dust or other matter adheres to the USB terminal, it may result in the outbreak of
smoke or fi re.
NOTE:
Note that there are USB devices that cannot be used.
1.
Check to confi rm that the power switch is off .
Check to confi rm that the power switch on the switch
panel is not illuminated.
2. Check to confi rm that the switch on the USB device to be
connected is off .
Plugging the USB device in adapter with the switch set at
on may result in unexpected operations, leading to injury.
3. Connect the USB cable. (Fig. 14)
Peel back the rubber cover and plug a USB cable that
matches the device and is available on the open market
as far as it will go into the USB terminal.
4.
Switch on the main switch to the Back Pack Power Supply
and the power switch.
Switch on the main switch to the Back Pack Power
Supply. Then switch on the power switch on the switch
panel to illuminate the power indicator in green and
commence supplying DC5V power to the USB device
connected.
5.
Removing the USB cable.
Disconnect the USB cable from USB terminal after use
and then seal the USB terminal with the rubber cover.
16
USB terminal
USB
Rubber cover
device
USB cable
Fig. 14
Publicité
Table des Matières
