Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
1.
Connect the charger's power cord to the receptacle.
When connecting the plug of the charger to a receptacle,
the pilot lamp will blink in red. (At 1-second intervals)
2. lnsert the adaptor of back pack power supply into the
charger.
Place the back pack power supply in a horizontal position
and turn it on by the switch on the side. Firmly insert the
adaptor into the charger until the line is visible, as shown
in Fig. 9.
NOTE:
If the pilot lamp of the charger lights in green (high temperature standby status) when the
adaptor is inserted into the charger, check that the battery status lamp on the back pack
power supply control panel is lit in red.
If the battery status lamp is OFF, the back pack power supply switch may be turned OFF.
If the back pack power supply switch is turned OFF, disconnect the adaptor and turn on the
switch before reinserting the adaptor.
3. Charging
When inserting an adaptor of back pack power supply in the charger, the pilot lamp will
light up continuously in red.
When the back pack power supply becomes fully recharged, the pilot lamp will blink in red.
(At 1-second intervals.) (See Table 1)
(1) Lamp indication
The indications of the pilot lamp will be as shown in Table 1, according to the condition of
the charger or the back pack power supply.
Before
charging
While
The
charging
pilot
lamp
lights or
Charging
blinks in
complete
red.
Charging
impossible
The
pilot
Overheat
lamp
standby
lights in
green.
NOTE: The cooling fan does not rotate while the back pack power supply is charging.
12
Indications of the pilot lamp
Lights for 0.5 seconds. Does not
light for 0.5 seconds. (off for 0.5
Blinks
seconds)
Lights continuously
Lights
Lights for 0.5 seconds. Does not
light for 0.5 seconds. (off for 0.5
Blinks
seconds)
Lights for 0.1 seconds. Does not
light for 0.1 seconds. (off for 0.1
Flickers
seconds)
Lights continuously
Lights
Table 1
Switch
panel
Adapter
Back pack
power supply
Main switch
Pilot lamp
Fig. 9
Malfunction in the back
pack power supply or the
charger
Back pack power supply
overheated.
Unable to charge.
(Charging will commence
when back pack power
supply cools)
Publicité
Table des Matières
