Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
Installation
After connecting the video sources and the network to
the video network station, turn on the power switch
and set the IP address.
About the Operating Environment
The following operating environment is required to set
up the server and view the images.
• Computer: 400-MHz Pentium III with 64-MB RAM
or more
• Operating System: Windows 98, Windows Me,
Windows NT 4.0 SP5 or later, or Windows 2000
• Web browser: Internet Explorer 5.0, 5.5
Note
Before connecting an HSR-1/1P to the video network
station, verify that the HSR-1/1P software version is
2.01 or later. An HSR-1/1P with software version 1.xx
cannot be used with this device, so contact your Sony
Service Center for an upgrade, if needed.
Connections
Connect the video source, network and power to the
video network station as follows. Refer as needed to
the operating manuals of the devices to be connected.
1
Turn off any devices to be connected.
2
Connect any devices required to the input and
output terminals of the video network station.
Note
The S VIDEO terminal and the VIDEO 1 terminal
cannot both be connected at the same time.
3
Connect the supplied AC adapter to a power outlet
and to the AC IN terminal of the video network
station.
Confirm that the POWER indicator lights steadily.
8
IP Address Assignment
The video network station must be assigned an IP
address to allow access from computers on the
network.
Here we describe IP address assignment using the
ARP protocol. Further, the factory default setting for
the video network station's IP address is set to
192.36.253.80.
z Hint
• ARP requires that an IP address be downloaded for
each new device.
• ARP cannot be used beyond the router.
• This device supports BOOTP.
Preparation
Before assigning the IP address, make the following
preparations.
• Obtain an unused IP address from your network
administrator
• Make a note of the MAC address shown on the label
on the bottom of the video network station.
• If the video network station is to be assigned a host
name, refer to your system manual or contact your
network administrator.
Note
Check with your network administrator before
assigning the IP address to the video network station.
Publicité
Chapitres
Table des Matières
