Part Names And Functions; Front Panel - Sony SNT-V304 Guide De L'utilisateur

Part Names and Functions

Front Panel

S VIDEO
1 S VIDEO Input Terminal (4 pins)
Video sources that provide separate Y/C signals are
input here. The VIDEO 1 input terminal is not usable
when this terminal is used.
2 STATUS Indicator
Indicates the operating status of the unit.
Color Server Status
Orange The self-test is executing after turning power on.
(blinking)
Green Normal operation
Red Fault.
3 NETWORK Indicator
After the self-test is complete, this indicator shows the
connection status of the network.
Color Network Connection Status
Orange A 10-Mbps Ethernet connection has been
(blinking) established.
Green A 100-Mbps Ethernet connection has been
(blinking) established.
Red No network connection could be established.
4 POWER Indicator
This indicator remains lit while power is on. If this
indicator blinks or fails to light, a problem is occurring
with the video network station's power supply. Refer
to "If You Suspect a Problem" on page 42 for
remedies.
VIDEO 1
POWER
STATUS
NETWORK
1 2 34
6
VIDEO 2 VIDEO 3
75Ω OFF
1 2 3 4
75Ω ON
5
5 VIDEO 1 to VIDEO 4 BNC Input Terminals
Composite video signals can be connected here using
coaxial video cable. The video signal format is
automatically detected when an NTSC or PAL video
source is connected. However, the VIDEO 1 and S
VIDEO terminals cannot both be used at the same
time.
6 75-Ω Termination Switches
The termination resistance of each VIDEO input
terminal can be set on or off with these switches.
When the unit is shipped from the factory, all
termination switches are ON.
Note
When this server is connected in parallel with other
devices, turn the corresponding termination switch off.
7 RESET Switch
This switch returns the server settings to factory
default state. Refer to "Resetting to Factory Defaults"
on page 39 for details.
7
VIDEO 4
5