Connecting The Units - Pioneer DEX-P99RS Manuel D'installation

Connecting the units

— Place all cables away from moving parts, such
as gear shift and seat rails.
— Place all cables away from hot places, such as
near the heater outlet.
— Do not pass the yellow cable through a hole
into the engine compartment to connect to a
battery.
— Cover any disconnected cable connectors with
insulating tape.
— Do not shorten any cables.
— Never cut the insulation of the power cable of
this unit in order to share the power to other
equipment. Current capacity of the cable is
limited.
— Use a fuse of the rating prescribed.
— Never wire the speaker negative cable directly
to ground.
• Control signal is output through blue/white cable
when this unit is powered on. Connect it to an
external power amp's system remote control or
the vehicle's auto-antenna relay control terminal
(max. 300 mA, 12 V DC). If the vehicle is equipped
with a glass antenna, connect it to the antenna
booster power supply terminal.
• Never connect blue/white cable to external power
amp's power terminal. Also, never connect
it to the power terminal of the auto antenna.
Otherwise, battery drain or malfunction may
result.
• IP-BUS connectors are color-coded. Be sure to
connect connectors of the same color.
• Black cable is ground. This cable and other
product's ground cable (especially, high-current
products such as power amp) must be wired
separately. Otherwise, fire or malfunction may
result if they are accidentally detached.
• Refer to the owner's manual for details on
connecting the power amp and other units, then
make connections correctly.
• If the RCA pin jack on the unit will not be used,
do not remove the caps attached to the end of the
connector.
• When connecting tweeters, please confirm the
tweeter's usable frequency range. When you set
the cut-off frequency, set higher than the lowest
usable frequency of the tweeter.
• Auto TA uses higher range than 10 kHz for
measurement. Therefore, using the tweeter
that cannot reproduce 10 kHz frequency range
may damage the tweeter. When Auto TA&EQ is
operated, be sure to set the appropriate cut-
off frequency. Also, use the tweeter that can
reproduce 10 kHz at the lowest usable frequency.
3