Pioneer BCS303 Mode D'emploi page 16

16 Installation
3
Installation
Assemble the
speakers
3
Speaker Setup for BCS-707
Preparing the speakers
1. Attach the non-skid pads to the base of
each speaker stand bases, the subwoofer
and the centre speaker.
For speaker stand bases:
Use the supplied adhesive to attach four
middle pads to the base (bottom) of each
speaker stand base.
For subwoofer:
Use the supplied adhesive to attach four
large pads to the base of subwoofer.
middle non-skid pads
large non-skid pads
For centre speaker:
Use the supplied adhesive to attach four
small pads to the base of centre speaker.
2. Attach the speaker stand bases to the stems
using the screws provided.
Once you have aligned the stem and base,
secure with the small screws at the points
shown below. Note that the speaker should
face in the direction of the base of the
isosceles triangle.
Rear
Front
small non-skid pads