Publicité
Les langues disponibles
Les langues disponibles
It is recommended to keep the tool more than 5 cm away
from the tree, concrete block, brick, garden stone or the
like so that the tip of the nylon code does not contact the
hard obstacle and you can expect the best performance.
Start the trimmer before getting close to the grass to be
cut.
Cut the grass using the nylon cord tip by moving the
trimmer from right to left and proceed slowly, keeping the
trimmer at the angle of about 30 ﾟ in relation to the
ground surface.
When cutting high grass, cut in layers always beginning
from the top with each cut length short.
MAINTENANCE
WARNING:
Always be sure that the tool is switched off and
•
battery cartridge is removed before attempting
to perform inspection or maintenance on the
tool. Failure to switch off and remove the battery
cartridge may result in serious personal injury from
accidental start-up.
NOTICE:
Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may
result.
Replacing the nylon cord
WARNING:
Make sure that the cover of the nylon cutting
•
head is secured to the housing properly as
described below. Failure to properly secure the
cover may cause the nylon cutting head to fly apart
resulting in serious personal injury.
Use only 2.0 - 3.0 mm (0.08" - 0.12") diameter
•
nylon cord. Never use metal wire, rope or the
like.
Use
of
recommended nylon cord may cause damage to
the trimmer and result in serious personal injury.
2
3
012902
Press inward on the housing latches and lift upward to
remove the cover. Discard any of the remaining nylon
cord.
something
other
than
1. Cover
1
2. Latches
3. Press
3
1
012904
Hook the middle of the new nylon cord to the notch
located at the center of the spool between the 2 channels
provided for the nylon cord. One side of the cord should
be about 80mm (3-1/8") longer than the other side.
Wind both ends firmly around the spool in the direction
marked on the head for right hand direction indicated by
RH.
100mm
1
010774
Wind all but about 100 mm (3-15/16") of the cords,
leaving the ends temporarily hooked through a notch on
the side of the spool.
1
the
010775
Mount the spool in the housing so that the grooves and
protrusions on the spool match up with those in the
housing. Keep the side with letters on the spool visible on
the top. Then, unhook the ends of the cord from their
temporary position and feed the cords through the
eyelets to come out of the housing.
11
1. Spool
80mm
2. For right hand
rotation
2
1
1. Notches
1. Eyelets
Publicité
