Makita HRU01 Mode D'emploi page 10

2
012867
Set the protector so that the rib of the shaft fits into the
groove of the protector. Then fix the protector and the
protector cover to the clamp with two bolts as shown.
Tighten the right and left bolts evenly.
Installing nylon cutting head
CAUTION:
Only use the nylon cutting head with the
•
protector. Failure to do so may cause serious
personal injury.
NOTICE:
Be sure to use genuine Makita nylon cutting head.
•
Turn the tool upside down so that you can replace the
nylon cutting head easily.
2
012868
Before you mount the nylon cutting head, turn the cutter
holder until you can see a slit under the hole. Insert the
lock key through the hole so that the base does not turn.
Then screw the cutting head clockwise with holding the
lock key until the cutting head is locked firmly. After the
cutting head is mounted, remove the lock key. Make sure
that the cutting head is tightly attached to the tool before
use.
To remove the nylon
counterclockwise while holding the lock key.
CAUTION:
If the nylon cutting head accidentally impacts a
•
rock or hard object during operation, stop the
tool and inspect it for any damage. If the nylon
cutting head
immediately. Otherwise it may be fly apart and
cause serous personal injury.
1. Protector
2. Bolts
3. Protector cover
1
3
1. Lock key
2. Cutter holder
1
cutting head,
is damaged, replace
OPERATION
OPERATION
CAUTION:
Do not cut high grass at a time. Cutting high
•
grass at a time near the root may cause the tool
motor under overloaded as grass is entangled, and
may result in damage to the tool.
Do not contact the cutting head with the
•
ground surface. It may cause the motor under
overload, and result in damage to the tool.
Do not force the trimmer in densely grown grass.
•
012891
CAUTION:
Do not use the trimmer as if you dig out the ground
•
with it.
Cutting the grass near a tree, concrete block,
brick or garden stone
012890
Tilt the tool with paying attention that the tool does not
contact the ground surface. Approach the tip of the nylon
cord to the grass. Smooth feeding out may be needed
because the tip of the nylon cord touches the ground and
turn it
wears more quickly than usual.
NOTE:
Getting the trimmer too close to a tree, concrete
•
block, brick, garden stone or the like during the
edging work or similar cutting work may cause the
nylon cord to be cut off halfway inside the cutter
it
head. In that case, turn off the tool, remove the
cutting head and set the nylon cord properly again.
Regarding to how to set the nylon code, refer to the
section in "Maintenance".
10