Instruction Manual - AEG SLS 4702 Mode D'emploi & Garantie

General safety instructions
To avoid the risk of fi re or an electric shock, you should
not expose the device to rain or moisture. Consequently,
do not use the device in the immediate vicinity of water
- for example near a bath tub, a swimming pool or in a
damp cellar.
Use the device only for the intended purpose.
Only connect the device at a properly installed plug so-
cket. Pay attention that the specifi ed voltage corresponds
to the voltage of the plug socket.
When using external mains supply, pay attention to the
correct polarity and voltage. Always place the batteries in
the correct direction.
Assemble the device in such a way that the available
ventilation openings are not covered.
Do not insert any objects into the bass refl ex opening.
Never open the housing of the device. Incorrect repairs
can constitute a considerable risk for the user. Should the
device become damaged, in particular the mains supply
cable, do not operate the device any longer, but rather
have it repaired by an expert. Check the mains supply
cable regularly for damage.
For safety reasons a broken or damaged mains lead may
only be replaced by an equivalent lead from the manuf-
acturer, our customer service department or a similary
qualifi ed person.
If the device is not used for a longer period, remove
the plug connector from the plug socket or take out the
batteries.
These symbols may be found on the machine and are
intended to indicate the following:
The lightning symbol should advise the user
of parts in the inside of the device which carry
dangerously high voltage levels.
The symbol with an exclamation mark should
advise the user of important operation or
maintenance instructions in the accompanying
documentation.
Devices bearing this symbol work with a
„class 1 laser" for tracing the CD. The built-in
safety switches should prevent the user being
exposed to dangerous laser light, which is
invisible to the human eye, when the CD compartment is
opened.
Under no circumstances should these safety switches be
bypassed or manipulated, as this could result in a danger
of exposure to the laser light.
05-SLS 4702 AEG 31
Installation
• Remove all devices from the packing and replace the
internal packaging material back in the box.
• Retain the packaging if possible during the entire
guarantee period!
• Do not insert the plug of the subwoofer into the socket
until all loudspeakers and connections have been
correctly made!
For optimum installation of the loudspeakers, please
follow the instructions below:
Assembly of the Feet and
Connection of the Loudspeakers
1. First screw the tubes of the loudspeaker stands toge-
ther. Then attach each base to the assembled tubes.
2. Then pass the accompanying loudspeaker cable from
the bottom into the stand and out through the hole at
the top.
Tip: This is easier to do if you fi rst insert a rigid wire
(e.g. fl orist's wire) from the top into the opening in the
upright tube. With the help of an adhesive strip you
can then attach the loudspeaker wires to the bottom
of your wire. Then guide the loudspeaker wires
through the tube by pulling on the wire.
3. Now attach the loudspeaker to the top of the base by
fi rst inserting the supplied screws into the two drill ho-
les on the stand and then suspending the loudspea-
ker on them.
4. Now connect the cable to the loudspeakers. Ensure
the correct polarity (connect black to black and red to
red).
5. The cinch plug of the loudspeaker cable is now
connected to the AUDIO OUTPUT of the subwoofer
according to the loudspeakers.
Upper tube
Sleeve
Lower tube
Base
Fastening nut
31
26.04.2005, 9:56:16 Uhr