Ayce DF-HT5390P Mode D'emploi page 29

Note: The setting temperature should be higher than the ambient temperature.
Otherwise the appliance will not start heating.
When the ambient temperature achieves the target setting temperature, the appliance
will stop automatically. If the ambient temperature is 1°C less than setting
temperature, the appliance will restart.
NTC protection: The appliance with NTC protection. If the temperature around the
●
sensor is over 60°C, the NTC will be triggered to switch off the appliance.
The appliance can then only be re-started manually and the detected room temperature
must be less than 60°C.
Memory function in standby mode: When pressing the
●
under the standby mode. The appliance will memorize the previous using
setting(except timer setting) and work accordingly.
The brightness of the display section will be reduced to 1/3 of the normal brightness
●
after 1 minute of working to avoid the LED display dazzling at night; it will resume to
the normal brightness after operation.
There is a tip-over switch inside the heater, it will switch off the heater automatically if
●
the heater falls down.
Turn off the power switch when not using the appliance.
●
Notices
a) When the NTC is working, the LED displays "EE".
b) When the environment temperature is lower than -10°C, the LED displays "LO".
c) When the environment temperature is higher than 40°C, the LED displays "HI".
key to turn on the appliance
REMOTE CONTROL
Power button
Timer +(up) button
Timer – (down) button
Mode button (HI/LOW/ECO)
HOW TO INSTALL BATTERIES
1.Pull out the battery door at the back side of remote control (see Picture1).
2.Pay attention to the battery polarity, and insert the battery（CR2032 3V）into the tray of
the door (see Picture 2).
3.Push the battery door into the remote control.
Remote control Battery door
Picture 1
Picture 2
56 | 57
GB
Simulation fire button
Temp+(up)button
Temp-(down) button
Swing button