Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Note! Since the appliance and its heating elements are slightly greased when delivered,
there might be a slight development of smoke and odour the first time it is used. This is
harmless and stops after a short a while. Be sure to provide for sufficient ventilation
during such time.
Warning! Ensure that there is sufficient distance from the wall, fixtures or other appli-
ances. The distance must be at least 1 m to exclude the risk of fire.
INSTALLATION METHOD
1. Take the appliance out of the package.
2. There are 1 pc master device and 1 pc remote control in the package. (the base of the
device is non-detachable)
3. Check that the appliance shows no signs of damage before using it.
CONTROL PANEL
CONTROL PANEL BUTTONS INTRODUCTION
Turn on the power switch which at the back of the heater. The power indicator
●
with "BiBi" sound and the machine enters to Standby Mode.
Under standby mode，press
button to turn on/off the simulation fire.
●
Under standby mode, press
key to turn on/off the machine.
●
Note: If turn off the appliance and the fan would stop working after 10s.
In working condition，press
to shift the power between low level and high level.
●
a) Low power: 1300W heating with
b) High power: 2000W heating with
In working condition，press
key to enter into the ECO mode，press again to quit
●
ECO
this mode. Temperature setting function is not working at this ECO mode.
Note: ECO mode：the default temperature setting is 22°C, when the room tempera-
ture is lower than 18°C, the machine works with high power; When the room tempera-
ture is between 18°C and 22 °C, the machine works with low power. When the room
temperature is above 22°C,the heating & swing function will turn off. In working
condition，press
button to turn on/off the swing function.
......
In working condition，press +
●
Note: The timer will start working after setting 5 seconds.
If the timer function is used, the LED display will show the setting temperature and
timer information by each 30 seconds interactively.
......
In working condition，press +
●
to 35°C.
54 | 55
DISPLAY PANEL
indicator lights up.
indicator lights up.
......
or
- button to set the timer from 0 to 24 hours.
......
or
- button to set the temperature from 15°C
GB
is on
Publicité
