Power Cord Connection; Attaching The Ferrite Core - Hitachi CMP5000WXE Manuel Utilisateur

Installation and Connections

Power Cord Connection

Connect a power cord after all component connections
have been completed.
CAUTION
÷ Do not use a power supply voltage other than that indicated
(AC 100 - 240 V, 50/60 Hz) as this may cause fire or electric
shock.
÷ For the plasma display, a three-core power cord with a ground
terminal is used for efficiency protection. Always be sure to
connect the power cord to a three-pronged grounded outlet
and make sure that the cord is properly grounded. If you use a
power source converter plug, use an outlet with a ground
terminal and screw down the ground line.

Attaching the Ferrite Core

To help prevent noise, attach the accessory ferrite core to
the plug end of the power cord as shown in the
accompanying illustration. Use the provided cable tie to
prevent the ferrite core from slipping on the cable.
To power
AC power cord
outlet
As close as possible
12
En
Ferrite core
Cable tie
To AC INLET