AEG FAVORIT 57202W0 Notice D'utilisation page 22

22 www.aeg.com
6.1 Adjusting the water softener
German
degrees
(°dH)
> 24
18- 24
12- 18
4 - 12
1) Factory position.
2) Do not use salt at this level.
Electronic adjustment
1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer to
'Setting and starting a programme'.
2. Press and hold function buttons (B)
and (C) at the same time until the in-
dicators of function buttons (A), (B)
and (C) start to flash.
3. Press function button (A).
• The indicators of function buttons
(B) and (C) go off.
6.2 Filling the salt container
French
degrees
32 - 40
19 - 32
< 4
Water hardness
mmol/l
(°fH)
> 40 > 4.2
3.2 - 4.2
2.1 - 3.2
7 - 19 0.7 - 2.1
< 7 < 0.7
4. Press function button (A) again and
5. Deactivate the appliance to confirm
1.
2.
3.
4.
5.
Clarke
degrees
28
22 - 28
13 - 22
5 - 13
< 5
• The indicator of function button (A)
continues to flash.
• The acoustic signals operate, e.g.
five intermittent acoustic signals =
level 5.
• The display shows the current set-
ting of the water softener, e.g.
= level 5.
again to change the setting.
the setting.
Turn the cap counterclockwise and
open the salt container.
Put 1 litre of water in the salt con-
tainer (only for the first time).
Fill the salt container with dishwash-
er salt.
Remove the salt around the opening
of the salt container.
Turn the cap clockwise to close the
salt container.
Elec-
tronic
adjust-
ment
5
4
1)
3
2
2)
1