Maruyama B23C Manuel Du Propriétaire page 16

2. The Trimmer must be on the operator's right side.
3. The operator's right hand should be holding the shaft
grip, with his or her fingers on the throttle trigger. The
right arm should be slightly bent.
4. The left hand should be holding the loop handle with
the fingers and thumb fully enclosed around the grip.
The left arm may be extended. Reposition the loop
handle up or down the driveshaft if necessary for a
comfortable position.
5. The trimmer weight should be evenly distributed
between the arms. The cutting attachment should be
near and parallel to the ground.
6. Accelerate and hold the engine at cutting speed before
entering the material to be cut.
7. Always release the throttle trigger and allow the
engine to return to idle speed when not cutting.
8. Stop the engine when moving between work sites.
• If the trimmer head becomes jammed, stop the
engine immediately.
• Make certain all moving parts have stopped and
disconnect the spark plug before inspecting the
equipment for damage.
• Never use a String Trimmer that has chipped, cracked
or broken trimmer head.
― US-15 ―