Extel WECA 109059 Mode D'emploi page 33

1. LIST OF PARTS
2. PARTICULAR NOTES
IMPORTANT :
This "coded" door handle intervenes on the same latch bolt (activated by the handle) but does not
have influence on the dead bolt (lock activated by the key).
It does not replace the key closure of the door.
ALWAYS START BY PRESSING ON "C" BEFORE ENTERING THE CODE, then no order in the
numbering is requested.
Before starting the installation:
According to the direction of the opening, you shall adapt the handle of the
"keypad block" and the one of the "handle block" to the left or right opening
of the door.
a - Keypad block:
Remove the "keypad block" from its support.
Take advantage of this access to note the factory pre-programmed code.
8F
2EN
a) Keyboard block (outside)
b) handle block (inside).
c) "cylinder" embellishment
front panels
d) "long" guide and "medium"
guide
f) "short" guide
g) long assembly screw
h) short assembly screw
i) pliers
j) adapters for 8mm square
j) adapters for 7mm square
l) spare pins
m) springs to maintain
the adapters