How To Use The Rooter - Hitachi M 12V2 Mode D'emploi

English
HOW TO USE THE ROUTER
1. Adjusting depth of cut
(1) Place the tool on a flat wood surface.
(2) Turn the quick adjustment lever in a
counterclockwise direction until the quick
adjustment lever stops. (Fig. 4)
(3) Turn the stopper block so that section to
which the cutting depth setting screw on a
stopper block is not attached comes to the
bottom of the stopper pole. Loosen pole lock
knob allowing the stopper pole to contact
with stopper block.
(4) Loosen the lock lever and press the tool
body until the bit just touches the flat
surface. Tighten the lock lever at this point.
(Fig. 5)
(5) Tighten pole lock knob. Align the depth
indicator with the "0" graduation of scale.
(6) Loosen pole lock knob, and raise until
indicator aligns with the graduation
representing the desired cutting depth.
Tighten pole lock knob.
(7) Loosen the lock lever and press the tool
body down until the stopper block to obtain
the desired cutting depth.
Your router allows you to finely adjust depth of cut.
(1) Attach the accessory knob to fine
adjustment knob. (Fig. 6)
(2) Turn the quick adjustment lever in a
clockwise direction until the quick
adjustment lever stops with the stopper
screw. (Fig. 7)
If the quick adjustment lever does not stop
with the stopper screw, the bolt screw is not
properly fitted.
If this occurs, slightly loosen the lock lever
and press down on the unit (router) hard
from the top and turn the quick adjustment
lever again after properly fitting the bolt
screw.
(3) The depth of cut can be adjusted when the
lock lever is loosened, by turning the fine
adjustment knob. Turning the fine
adjustment knob counterclockwise results
in a shallower cut, whereas turning it
clockwise results in a deeper cut.
12
Stopper pole
Scale
Quick
adjustment
lever
Stopper
block
Fig. 3
Loosen the
lock lever
Fig. 5
Fig. 6
Depth
indicator
Pole lock
knob
Quick adjustment
lever
Fig. 4
Knob
Fine
adjustment
knob