Good Energies B-CURE LASER PRO Mode D'emploi page 5

Masquer les pouces Voir aussi pour B-CURE LASER PRO:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
During treatment, you will see a green light indicating the device is functioning. "Beep" sounds at 3 second intervals
indicate that the device is functioning and that the stopwatch is counting down until reaching "00:00" at which time
the device's functioning will automatically end and the "Beep" sound will stop. Hold the device on the skin steadily
and motionless during the whole duration of the treatment.
Demonstration of the activation of the laser beam after setting treatment time
1
Step
After setting the treatment time,
press the "treatment start
push-button"
6.4 End of treatment, reset and turn OFF
To switch off the device, press the main power switch until a beep sounds. Release the button and the display will
go blank. If the planned treatment time has not been fully utilized, the timer will display the remaining time at startup.
To reset the timer, switch off the device, then press the main power switch for longer than 2 seconds while switching
on the device.
7. Treatment protocol
7.1 Intended use
B-Cure Laser is intended for the management of pain including: Chronic back pain; Chronic neck pain; Knee pain;
Carpal Tunnel Syndrome (CTS); Fibromyalgia; Myofascial Pain Syndrome (MPS); Temporomandibular Joint Disorder;
May help as an adjunctive treatment for acute and chronic wounds.
7.2 Treatment course and dosage
Start treatment in 1.5 minute dosage for each treatment point and increase the dosage gradually within 24 hours
until you reach 8 min. Treat twice a day, consistently. If you experience increased pain following treatment, stop the
treatment for 24 hours then start again with a reduced dosage. You may increase the dosage to 4 treatments a day.
In cases of acute pain, trauma or non-chronic aches, you may apply a dosage of 8 minutes from the first treatment.
2
Step
Continue pressing and
simultaneously press using an
additional finger on the pressure
switch area
3
Step
Release both buttons
simultaneously. Now the green
light is on and treatment
can begin
5

Publicité

Table des Matières
loading

Produits Connexes pour Good Energies B-CURE LASER PRO

Ce manuel est également adapté pour:

B-cure laser sport pro

Table des Matières