Hama 00186417 Mode D'emploi page 6

Note
• The wireless transmission range between the
measuring and base stations is up to 50 m in open
spaces.
• Before installation, ensure that wireless transmission
will not be disrupted by interference or obstacles like
buildings, trees, vehicles, high-voltage lines, etc.
• Before the final installation, ensure that there is
sufficient reception between the intended installation
locations.
• When installing the measuring station, ensure that it
is protected from direct sunlight and rain.
• The international standard height for measuring air
temperature is 1.25 m (4 ft) above ground.
Warning
• Buy special or suitable installation material from a
specialised dealer for wall-mounting.
• Ensure that no faulty or damaged parts are installed.
• Never apply force during installation. This could
damage the product.
• Before installation, ensure that the chosen wall is
suitable for the weight to be mounted, and make sure
that there are no electrical wires, water, gas or other
lines at the installation site on the wall.
• Do not mount the product above locations where
persons might linger.
5.1 Base station
• Use the base (G) to position the base station on a level
surface.
• Alternatively, you can install the base station on a wall
using the opening (I) on the back.
5.2 Measuring station
• You can also position the measuring station on a level
outdoor surface.
• We recommend installing the measuring station securely
on an outdoor wall.
• Install an anchor, screw, nail, etc. in the wall of your
choice.
• Hang up the base/measuring station using the opening
intended for this purpose.
6. Operation
Note – Input
• Hold the button (B) or the
the values faster.
6.1 Connection to the measuring station
• After you insert the batteries, the base station
automatically searches for a connection to the
measuring station and performs initial setup.
Note
• Initial setup takes approximately 3 minutes.
• During the connection attempt, the radio symbol on
the measuring station will flash.
• Do not press any buttons during setup. Otherwise,
values may not be transmitted correctly and there is a
risk of value errors and inaccuracies.
• The setup process is completed when the indoor and
outdoor measurement data (10/19) is displayed.
• If the base station still does not receive a signal from
the measuring station, press and hold the CHANNEL
button (D) for approximately 3 seconds to start the
manual search for the signal.
Note – Faulty transfer of measured
values
• In isolated cases, interference - e.g. from a WLAN
network, a computer or a television set - can
cause the transfer of measured values between the
measuring station and the base station to fail.
button (C) to select
5