Sage the Nutri Juicer Guide Rapide page 7

TROUBLESHOOTING
POSSIBLE PROBLEM EASY SOLUTION
Pulp too wet and • Try a slower juicing action. Remove the stainless steel filter
reduced extracted juice basket and thoroughly clean mesh walls with a cleaning
brush. Rinse the filter basket under hot water. If the fine
mesh holes are blocked, soak the basket in a solution of hot
water with 10% lemon juice to unlock the holes or wash in
the dishwasher. This will remove excess fibre build up (from
fruit and vegetables) which could be inhibiting the flow.
Juice leaks between the • Try a slower juicing speed and push the food pusher down
rim of the Juicer and the the feed chute more slowly.
juicer cover
• Ensure all parts are securely pieced together, with the
interlocking arm in place.
Juice sprays out • The juice is being extracted too fast: try a slower juicing
from spout
speed and push the food pusher down the feed chute
more slowly.
Overheating with • The juicer is fitted with a safety device which safeguards
excessive loads. against overheating with excessive loads. If overheating
occurs, the juicer will automatically activate the overload
protection device and the unit will switch itself off. When the
overload protection is activated, unplug the Juicer from the
power outlet for at least 15 minutes to allow the unit to cool.
Then plug the juicer into the power outlet and use as normal.
• It is important to ensure the juicer is turned on and the motor
is running prior to loading the chute. Do not put excessive
loads in the feed chute and ensure the filter basket is totally
clear of any food build up, on the blades and mesh, as this
can result in unnecessary resistance against the motor
resulting in overheating.
12
NOTES
EN
13